Trabiss Touchprobe
Trabiss Touchprobe is a rugged and compact touchprobe with 5-way trigger stylus. It can be used for conventional
milling machines and CMMs (coordinate measuring machines).
Strong advise to calibrate it before use!
- 6061-T6 black anodized aluminium body and stainless steel shaft
- Anti-oxidizing electrical system covered with dielectric fluid
- Modular construction
- Ingress protected against dust and splashes of water from all directions
- Probe is designed with normally closed internal switch contacts
- Shielded flexible cable with quick action connector
- Each probe is tested before being shipped
- Probe is designed with normally closed internal switch contacts
- Concentric calibration 4 or 3 set screws with included Allen key
- Optically calibrated before shipment
- Standard M3x0.5 probe tip Ruby
Approach direction | ±X, ±Y, ±Z |
Repeatability | 2 µm |
Trigger force | Axial=5 N, Radial=1 N |
Mass | 160 gr |
Over travel protection distance | Radial 8mm (with 31mm Stylus), Axial 5mm |
Dimensions | Ø 40 mm, H 35 mm, Shaft 20 mm |
Included cable length | 3m |
Resistance | Closed = 10-30 Ω, Open = ∞ |
Shaft diameter | 7 mm +0.0/-0.05 mm |